Race Car for Sale

 

Race Car for Sale: 2000 Porsche GT3 Cup Car

 

$49,500.00

 

 

Picture taken on July 10, 2010

 

More images can be found here.

 

We are proud to offer an original 2000 Porsche GT3 Cup Car. This is a race car prepared at the Porsche factory.

 

Porsche delivered this car to Team Kadach early 2000 for the Supercup Series. The driver that year was Alessandro Zampedri, who actually signed the car. The original "Wagenpasz" documents this history.

 

After the Indianapolis event in September 2000, the car was left in the USA with a rebuilt engine installed. It was used in 2001 in California and from 2002-2008 in the Pacific Northwest, mostly two to three events per year at Porsche Club Racing and SCCA at P.I.R.

 

This race car has been maintained by Rothsport Racing, the Porsche race car expert in the area. The car was dyno'ed on July 13, 2010 at Carburator Connection in Kirkland WA (425-8201871). Max STD power was measured as 353.26 HP at 7200 RPM, max STD Torque as 270.61 at 5700 RPM; Air/Fuel ratio was consistently around 13.5. These measurements are at the rear wheels and were done in 4th gear.

 

 

Upgrades to the car include:

 

bullet

Aerodynamic wing as used in Cup Cars from 2002 and on

bullet

Moton double adjustable shocks all around

bullet

Rothsport special exhaust

bullet

Upgraded cooling system hoses

 

Original parts are included with the car

 

Only small racing fender bender accidents, expertly repaired, never a major crash. The bodywork of this racecar is in good shape, incl. a brand new windshield.

 

Included with the car:

 

bullet

TWO extra sets of wheels

bullet

TWO large nitrogen cylinders (with dual regulator)

bullet

AIRJACK wand and hose. 

bullet

Logbooks for PCA racing and SCCA

bullet

Transponder

bullet

Fire system with oversized Fire Bottle (and oversized clamps)

 

Other:

 

bullet

Airjacks were rebuilt and replaced where necessary

bullet

Estimated run-time since 2001 (when the current engine was installed) is between 50 and 60 hours.

bullet

Engine power on chassis dyno at rear wheels: about 352 HP (tested on July 13, 2010)

bullet

Transmission rebuilt, clutch and fuel pump replaced in 2008. Used one event only.

bullet

Windshield replaced March 2010.

bullet

Safety belts good through 2010

 

 

Separately available: 24' trailer with built-in storage for the extra 2 sets of wheels, special ramps and tie downs. ($5000)

 

Contact Jan at (503) 410-9850 or email:

More images can be found here.

 

horizontal rule

Home Next